SOURCES SOUGHT NOTICE USCGC THETIS (WMEC 910) DRYDOCK REPAIRS FY26 This is a SOURCES SOUGHT NOTICE / REQUEST FOR INFORMATION; not a pre-solicitation notice or solicitation for proposals/quotations. Pursuant to FAR Part 10 (Market Research), the purpose of this notice is to: (1) determine if sources capable of satisfying the agency's requirements exists, (2) determine if commercial items suitable to meet the agency's needs are available or could be modified to meet the agency's requirements, and (3) determine the commercial practices of company's engaged in providing the needed service or supply. Pursuant to FAR Part 6 and FAR Part 19, competition and set-aside decisions may be based on the results of this market research. This notice in no way obligates the Government to any further action. REQUIREMENT: This notice is issued by the U.S. Coast Guard, Surface Forces Logistics Center, and Norfolk, VA to identify sources capable of providing the following: DRYDOCK REPAIRS SPECIFICATION: (Subject to change at the discretion of the Government). Contractor shall provide all necessary facilities, materials, equipment, and personnel to perform DRYDOCK repairs to the U.S. Coast Guard Cutter (USCGC) THETIS (WMEC 910). The vessel is home ported in KEY WEST, FL. All work will be performed at the contractor facility. There is no geographical restriction for this cutter. SCOPE OF WORK: The scope of the acquisition is for the DRYDOCK repairs of the USCGC THETIS (WMEC 910). This work will include, but is not limited to the following Work Items: WORK ITEM 1: Hull Plating, U/W Body, Ultrasonic Testing WORK ITEM 2: U/W Body, Preserve, 100 percent WORK ITEM 3: Hull Plating Freeboard, Preserve, Partial WORK ITEM 4: Propulsion Shaft Fairwaters and Rope Guards, Renew WORK ITEM 5: Appendages (U/W), Preserve (Internal) and Leak Test WORK ITEM 6: Voids (Non-Accessible), Preserve (Internal) and Leak Test WORK ITEM 7: Propulsion Shafting, Strain Gauge Alignment, Drydock, Check WORK ITEM 8: Prop